[   16.116328] amd64_edac: probe of 0000:00:18.2 failed with error -22
[   16.146805]   alloc irq_desc for 20 on node 0
[   16.146806]   alloc kstat_irqs on node 0
[   16.146815] SB-XFi 0000:03:06.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
[   16.446451] HDA Intel 0000:00:14.2: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   16.447984] Console: switching to colour frame buffer device 80x30
[   16.585076] hda_codec: ALC889A: BIOS auto-probing.
[   16.586390] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:14.2/input/input6
[   16.595702] HDA Intel 0000:01:05.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19
[   16.595735] HDA Intel 0000:01:05.1: setting latency timer to 64
[   21.128805] type=1505 audit(1284876616.443:5):  operation="profile_load" pid=1074 name="/usr/share/gdm/guest-session/Xsession"
[   21.129643] type=1505 audit(1284876616.443:6):  operation="profile_replace" pid=1075 name="/sbin/dhclient3"
[   21.129811] type=1505 audit(1284876616.443:7):  operation="profile_replace" pid=1075 name="/usr/lib/NetworkManager/nm-dhcp-client.action"
[   21.129906] type=1505 audit(1284876616.443:8):  operation="profile_replace" pid=1075 name="/usr/lib/connman/scripts/dhclient-script"
[   21.131528] type=1505 audit(1284876616.453:9):  operation="profile_load" pid=1076 name="/usr/bin/evince"
[   21.133597] type=1505 audit(1284876616.453:10):  operation="profile_load" pid=1076 name="/usr/bin/evince-previewer"
[   21.134905] type=1505 audit(1284876616.453:11):  operation="profile_load" pid=1076 name="/usr/bin/evince-thumbnailer"
[   21.137574] type=1505 audit(1284876616.453:12):  operation="profile_load" pid=1080 name="/usr/lib/cups/backend/cups-pdf"
[   21.137779] type=1505 audit(1284876616.453:13):  operation="profile_load" pid=1080 name="/usr/sbin/cupsd"
[   21.138850] type=1505 audit(1284876616.453:14):  operation="profile_load" pid=1081 name="/usr/sbin/tcpdump"
[   21.162953] r8169: eth0: link up
[   21.162959] r8169: eth0: link up
[   21.357021] ppdev: user-space parallel port driver
[   21.409851] [fglrx] GART Table is not in FRAME_BUFFER range
[   21.409978]   alloc irq_desc for 28 on node 0
[   21.409980]   alloc kstat_irqs on node 0
[   21.409986] fglrx_pci 0000:01:05.0: irq 28 for MSI/MSI-X
[   21.410363] [fglrx] Firegl kernel thread PID: 1216
[   21.410597] [fglrx] IRQ 28 Enabled
[   22.127204] [fglrx] Gart USWC size:1079 M.
[   22.127207] [fglrx] Gart cacheable size:428 M.
[   22.127210] [fglrx] Reserved FB block: Shared offset:0, size:1000000
[   22.127212] [fglrx] Reserved FB block: Unshared offset:27ffb000, size:5000
[   31.970012] eth0: no IPv6 routers present
[   33.321599] NET: Registered protocol family 24
[   92.558497] tvtime[1865]: segfault at 840 ip 0000000000407400 sp 00007fff0a14def8 error 4 in tvtime[400000+7e000]
[  101.019055] tvtime[1867]: segfault at 840 ip 0000000000407400 sp 00007fffcbf10a48 error 4 in tvtime[400000+7e000]
[  280.339771] tvtime[1947]: segfault at 840 ip 0000000000407400 sp 00007fff73a4c898 error 4 in tvtime[400000+7e000]
[  695.532259] tvtime[2008]: segfault at 840 ip 0000000000407400 sp 00007fff841fae18 error 4 in tvtime[400000+7e000]
[35533.450066] usb 1-2: new high speed USB device using ehci_hcd and address 5
[35533.603511] usb 1-2: configuration #1 chosen from 1 choice
[35533.603858] scsi7 : SCSI emulation for USB Mass Storage devices
[35533.604043] usb-storage: device found at 5
[35533.604050] usb-storage: waiting for device to settle before scanning
[35538.600325] usb-storage: device scan complete
[35538.600896] scsi 7:0:0:0: Direct-Access              USB FLASH DRIVE  PMAP PQ: 0 ANSI: 0 CCS
[35538.602262] sd 7:0:0:0: Attached scsi generic sg8 type 0
[35541.264137] sd 7:0:0:0: [sdh] 16121856 512-byte logical blocks: (8.25 GB/7.68 GiB)
[35541.264622] sd 7:0:0:0: [sdh] Write Protect is off
[35541.264629] sd 7:0:0:0: [sdh] Mode Sense: 23 00 00 00
[35541.264635] sd 7:0:0:0: [sdh] Assuming drive cache: write through
[35541.266996] sd 7:0:0:0: [sdh] Assuming drive cache: write through
[35541.267004]  sdh: sdh1
[35541.270037] sd 7:0:0:0: [sdh] Assuming drive cache: write through
[35541.270046] sd 7:0:0:0: [sdh] Attached SCSI removable disk
[35718.560058] usb 1-4: new high speed USB device using ehci_hcd and address 6
[35718.711853] usb 1-4: configuration #1 chosen from 1 choice
[35718.712308] scsi8 : SCSI emulation for USB Mass Storage devices
[35718.712553] usb-storage: device found at 6
[35718.712558] usb-storage: waiting for device to settle before scanning
[35723.710328] usb-storage: device scan complete
[35723.711022] scsi 8:0:0:0: Direct-Access     USB      Flash Drive      1.00 PQ: 0 ANSI: 2
[35723.712378] sd 8:0:0:0: Attached scsi generic sg9 type 0
[35723.712983] sd 8:0:0:0: [sdi] 1968000 512-byte logical blocks: (1.00 GB/960 MiB)
[35723.714615] sd 8:0:0:0: [sdi] Write Protect is off
[35723.714625] sd 8:0:0:0: [sdi] Mode Sense: 23 00 00 00
[35723.714631] sd 8:0:0:0: [sdi] Assuming drive cache: write through
[35723.717882] sd 8:0:0:0: [sdi] Assuming drive cache: write through
[35723.717893]  sdi: sdi1
[35723.720727] sd 8:0:0:0: [sdi] Assuming drive cache: write through
[35723.720738] sd 8:0:0:0: [sdi] Attached SCSI removable disk
[36119.450067] usb 6-1: new full speed USB device using ohci_hcd and address 2
[36119.646884] usb 6-1: configuration #1 chosen from 1 choice
[36119.748866] usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x04B8 pid 0x0005
[36119.748903] usbcore: registered new interface driver usblp
[36121.092162] usb 6-1: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[36621.418384] usb 1-2: USB disconnect, address 5
[38697.093939] usb 2-3: USB disconnect, address 2
[39364.980064] usb 1-2: new high speed USB device using ehci_hcd and address 7
[39365.133524] usb 1-2: configuration #1 chosen from 1 choice
[39365.134601] scsi9 : SCSI emulation for USB Mass Storage devices
[39365.134869] usb-storage: device found at 7
[39365.134874] usb-storage: waiting for device to settle before scanning
[39370.132816] usb-storage: device scan complete
[39370.133404] scsi 9:0:0:0: Direct-Access              USB FLASH DRIVE  PMAP PQ: 0 ANSI: 0 CCS
[39370.134898] sd 9:0:0:0: Attached scsi generic sg8 type 0
[39372.816904] sd 9:0:0:0: [sdh] 16121856 512-byte logical blocks: (8.25 GB/7.68 GiB)
[39372.817391] sd 9:0:0:0: [sdh] Write Protect is off
[39372.817393] sd 9:0:0:0: [sdh] Mode Sense: 23 00 00 00
[39372.817396] sd 9:0:0:0: [sdh] Assuming drive cache: write through
[39372.819774] sd 9:0:0:0: [sdh] Assuming drive cache: write through
[39372.819779]  sdh: sdh1
[39372.822882] sd 9:0:0:0: [sdh] Assuming drive cache: write through
[39372.822886] sd 9:0:0:0: [sdh] Attached SCSI removable disk
[39447.405138] usb 1-2: USB disconnect, address 7
[42380.723480] tvtime[8422]: segfault at 840 ip 0000000000407400 sp 00007fff8ee4d878 error 4 in tvtime[400000+7e000]

Running tvtime 1.0.2.
Reading configuration from /etc/tvtime/tvtime.xml
I/O warning : failed to load external entity "/home/cj/.tvtime/tvtime.xml"
I/O error : Permission denied
I/O error : Permission denied
Cannot change owner of /home/cj/.tvtime/tvtime.xml: Отказано в доступе.
videoinput: Cannot open capture device /dev/video0: Нет такого файла или каталога
I/O error : Permission denied
I/O error : Permission denied
Ошибка сегментирования

WARNING: All config files need .conf: /etc/modprobe.d/behold, it will be ignored in a future release.
WARNING: Error inserting videobuf_core (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/videobuf-core.ko): Operation not permitted
WARNING: Error inserting videobuf_dma_sg (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/videobuf-dma-sg.ko): Operation not permitted
WARNING: Error inserting v4l2_compat_ioctl32 (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/v4l2-compat-ioctl32.ko): Operation not permitted
WARNING: Error inserting v4l1_compat (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/v4l1-compat.ko): Operation not permitted
WARNING: Error inserting videodev (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/videodev.ko): Operation not permitted
WARNING: Error inserting v4l2_common (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/v4l2-common.ko): Operation not permitted
WARNING: Error inserting ir_common (/lib/modules/2.6.32-25-generic/kernel/drivers/media/common/ir-common.ko): Operation not permitted
FATAL: Error inserting saa7134 (/lib/modules/2.6.32-25-generic/kernel/drivers/media/video/saa7134/saa7134.ko): Operation not permitted

sudo modprobe saa7134 alsa=1 secam=d
WARNING: All config files need .conf: /etc/modprobe.d/behold, it will be ignored in a future release.